Industrial Safety Warning Marking Red White Belt To Indicate Danger Prohibition
The red–white belt is an industrial safety and warning marking commonly used to indicate danger, prohibition, or the location of firefighting equipment. It consists of alternating red and white diagonal stripes, typically at a 45° angle, designed to attract attention and increase visibility in hazardous or restricted areas.
- Transmission Line Wire Cable Conductor Tension Stringing Equipment
- Transmission Conductor Tension Stringing Equipment For Overhead Power Lines
- Tools For Power Lines,Substation,Electrical Construction & Maintenance
- Electric Power Transmission Distribution Line Construction Machine Tools
- Overhead Power Transmission Distribution Line Repair Hardware Fittings
- Underground Cable Laying Pulling Installation Equipment Machine Tools Accessories
- Information
- Video
The red–white belt is an industrial safety and warning marking commonly used to indicate danger, prohibition, or the location of firefighting equipment. It consists of alternating red and white diagonal stripes, typically at a 45° angle, designed to attract attention and increase visibility in hazardous or restricted areas.
-
: It serves as a hazard warning marking to identify moving danger points, restricted zones, or areas where special caution is required, such as around machinery, electrical panels, or emergency equipment.
-
: The red and white color combination complies with safety standards like DIN 4844 and IS 9457, which specify the use of red for danger and prohibition, and white for contrast to enhance visibility.
-
: The stripes are of equal width and inclined at about 45°, with alternating red and white rhombs or bands. Narrower stripes increase the warning effect in small or narrow areas.
-
:
-
Marking hazardous areas or equipment.
-
Indicating fire protection equipment locations (fire extinguishers, alarms).
-
Temporary barriers or crowd control using retractable belt posts with red-white belts for high visibility in warehouses, construction sites, and events.
-
-
: Not suitable for surfaces subject to heavy traffic, such as floors walked on or driven over by equipment, because adhesive markings may wear off quickly.
-
The red–white belt is a highly visible, standardized safety marking used primarily to denote danger, prohibition, or fire safety equipment locations. Its distinctive alternating red and white stripes provide clear visual warnings to prevent accidents and ensure compliance with occupational safety regulations. It is widely used in industrial settings, emergency restoration equipment, and temporary access control barriers.
